Powerley Smart Light Bulb

Take control of your lighting

Product Information

Specifications

Wattage (W) 9.0
Replacement Power (W) 60
Voltage (V) 120
Brightness 806 Lumens
Rated Lifetime 25,000 hours
Energy Savings $127 Lifetime Savings (estimated)
Yearly Energy Cost $1.64 (Based on 3 hours/day, $0.11kWh)
Color Temperature 2700/6500K
Dimmable Yes, via app
Light Transition
Beam Spread
Certifications Indoor Only
Base Type E26 Medium Standard Screw-type
Height 4.25 inches
Width 2.36 inches
Weight 4.1 oz
Beam Angle 240 Degrees
Operating Tempature -20 to 40 Degree C
Protocol Zigbee 3.0
Color Rendering Index (CRI) 90

Warranty Information:

90 day limited warranty from original purchase date.

Important Safety Information

  • Turn Off light switch connected to the socket where the light bulb is being replaced
  • Do not attempt to disassemble or change light bulb in anyway
  • Suitable for operating tempatures of -25C to 45C (-13F to 113F)
  • Indoor use only
  • NOT FOR USE IN EMERGENCY LIGHTING

Federal Communication Commission Statement

THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.4.

IC warning: This device complies with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator& your body. This transmitter must not be co-located or operating an conjunction with any other antenna or transmitter.Le rayonnement de la classe b repecte ISED fixaient un environnement non contrôlés. Installation et mise en œuvre de ce matériel devrait avec échangeur distance minimale entre 20 cm ton corps. Lanceurs ou ne peuvent pas coexister cette antenne ou capteurs avec d’autres.